Clarify PIO define is optional in docs. (#22339)
This commit is contained in:
parent
d2892685c5
commit
e0c00c35ce
|
@ -235,7 +235,7 @@ Where 'n' matches the peripheral number of your selected USART on the MCU.
|
||||||
|
|
||||||
The `PIO` subsystem is a Raspberry Pi RP2040 specific implementation, using the integrated PIO peripheral and is therefore only available on this MCU. Because of the flexible nature of the PIO peripherals, **any** GPIO pin can be used as a `TX` or `RX` pin. Half-duplex and Full-duplex operation is fully supported. The Half-duplex operation mode uses the built-in pull-ups and GPIO manipulation on the RP2040 to drive the line high by default. An external pull-up is therefore not necessary.
|
The `PIO` subsystem is a Raspberry Pi RP2040 specific implementation, using the integrated PIO peripheral and is therefore only available on this MCU. Because of the flexible nature of the PIO peripherals, **any** GPIO pin can be used as a `TX` or `RX` pin. Half-duplex and Full-duplex operation is fully supported. The Half-duplex operation mode uses the built-in pull-ups and GPIO manipulation on the RP2040 to drive the line high by default. An external pull-up is therefore not necessary.
|
||||||
|
|
||||||
Configure the hardware via your config.h:
|
You may optionally switch the PIO peripheral used with the following define in config.h:
|
||||||
```c
|
```c
|
||||||
#define SERIAL_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the Serial implementation uses the PIO0 peripheral
|
#define SERIAL_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the Serial implementation uses the PIO0 peripheral
|
||||||
```
|
```
|
||||||
|
|
|
@ -170,7 +170,7 @@ To configure it, add this to your rules.mk:
|
||||||
WS2812_DRIVER = vendor
|
WS2812_DRIVER = vendor
|
||||||
```
|
```
|
||||||
|
|
||||||
Configure the hardware via your config.h:
|
You may optionally switch the PIO peripheral used with the following define in config.h:
|
||||||
```c
|
```c
|
||||||
#define WS2812_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the WS2812 implementation uses the PIO0 peripheral
|
#define WS2812_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the WS2812 implementation uses the PIO0 peripheral
|
||||||
```
|
```
|
||||||
|
|
Loading…
Reference in New Issue