023d644bb6
* Move RGBLight animations to data driven, 0-9 * Move RGBLight animations to data driven, A * Move RGBLight animations to data driven, B * Move RGBLight animations to data driven, C * Move RGBLight animations to data driven, D * Move RGBLight animations to data driven, E * Move RGBLight animations to data driven, F * Move RGBLight animations to data driven, G * Move RGBLight animations to data driven, H * Move RGBLight animations to data driven, handwired * Move RGBLight animations to data driven, I * Move RGBLight animations to data driven, J * Move RGBLight animations to data driven, K * Move RGBLight animations to data driven, L * Move RGBLight animations to data driven, M * Move RGBLight animations to data driven, N * Move RGBLight animations to data driven, O * Move RGBLight animations to data driven, P * Move RGBLight animations to data driven, Q * Move RGBLight animations to data driven, R * Move RGBLight animations to data driven, S * Move RGBLight animations to data driven, T * Move RGBLight animations to data driven, U * Move RGBLight animations to data driven, V * Move RGBLight animations to data driven, W * Move RGBLight animations to data driven, X * Move RGBLight animations to data driven, Y * Move RGBLight animations to data driven, Z * Fix incorrect placement * Fix build failures and mismatches |
||
|---|---|---|
| .. | ||
| keymaps | ||
| config.h | ||
| halconf.h | ||
| info.json | ||
| matrix_diagram.md | ||
| mcuconf.h | ||
| readme.md | ||
| rev_b.c | ||
| rev_b.h | ||
| rules.mk | ||
readme.md
Viper/Eagle REP Rev B
A alternative PCB for Viper and Eagle V2 and V3
- Keyboard Maintainer: 4pplet
- Hardware Supported: Viper/Eagle REP Rev B
Make example for this keyboard (after setting up your build environment):
make 4pplet/eagle_viper_rep/rev_b:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
How to enter bootloader (DFU):
-
Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
-
Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.
Alternative option if the firmware is already pre-flashed:
- Unplug your keyboard, hold down the Esc-key and at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.