qmk_firmware/keyboards/cannonkeys/db60
Ryan 314f6c1ddb
Move backlight config to data driven (#19910)
2023-02-26 08:37:57 +11:00
..
hotswap Migrate some more layouts to data driven (#19889) 2023-02-23 09:32:18 +11:00
j02 Migrate some more layouts to data driven (#19889) 2023-02-23 09:32:18 +11:00
keymaps `cannonkeys/db60/hotswap`: fix layouts (#18982) 2022-11-07 16:16:41 +11:00
rev2 Migrate some more layouts to data driven (#19889) 2023-02-23 09:32:18 +11:00
chconf.h
config.h Move backlight config to data driven (#19910) 2023-02-26 08:37:57 +11:00
halconf.h
info.json Move backlight config to data driven (#19910) 2023-02-26 08:37:57 +11:00
mcuconf.h
readme.md
rules.mk Migrate `MCU` and `BOOTLOADER` to data-driven (#19529) 2023-02-08 18:41:46 +11:00

readme.md

CannonKeys DB60

DB60 "Daughterboard 60" Keyboard

  • Keyboard Maintainer: Andrew Kannan
  • Hardware Supported: STM32F072CBT6 (or equivalent)

Make example for this keyboard (after setting up your build environment):

make cannonkeys/db60/rev2:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Some notes about the versions: The original DB60 was shipped with the J-02. To build that, you will need to use the following command:

make cannonkeys/db60/j02:default

Solderable DB60s were shipped with keyboards after the J-02. This variant has cutouts along the top and bottom to support O-ring gasket mounting. To build these, you can use this command:

make cannonkeys/db60/rev2:default

Hotswap ANSI DB60s were shipped with the Bakeneko keyboards from CannonKeys. These also have the o-ring gasket mounting points. To build this:

make cannonkeys/db60/hotswap:default