56555c61e1
* Migrate `LAYOUTS` to data driven, 0-9 * Migrate `LAYOUTS` to data driven, A * Migrate `LAYOUTS` to data driven, B * Migrate `LAYOUTS` to data driven, C * Migrate `LAYOUTS` to data driven, D * Migrate `LAYOUTS` to data driven, E * Migrate `LAYOUTS` to data driven, F * Migrate `LAYOUTS` to data driven, G * Migrate `LAYOUTS` to data driven, H * Migrate `LAYOUTS` to data driven, handwired * Migrate `LAYOUTS` to data driven, I * Migrate `LAYOUTS` to data driven, J * Migrate `LAYOUTS` to data driven, K * Migrate `LAYOUTS` to data driven, L * Migrate `LAYOUTS` to data driven, M * Migrate `LAYOUTS` to data driven, N * Migrate `LAYOUTS` to data driven, O * Migrate `LAYOUTS` to data driven, P * Migrate `LAYOUTS` to data driven, Q * Migrate `LAYOUTS` to data driven, R * Migrate `LAYOUTS` to data driven, S * Migrate `LAYOUTS` to data driven, T * Migrate `LAYOUTS` to data driven, U * Migrate `LAYOUTS` to data driven, V * Migrate `LAYOUTS` to data driven, W * Migrate `LAYOUTS` to data driven, X * Migrate `LAYOUTS` to data driven, Y * Migrate `LAYOUTS` to data driven, Z |
||
|---|---|---|
| .. | ||
| keymaps | ||
| config.h | ||
| info.json | ||
| matrix.c | ||
| readme.md | ||
| rules.mk | ||
| sixkeyboard.c | ||
| sixkeyboard.h | ||
readme.md
Techkeys SixKeyBoard
Keyboard Maintainer: QMK Community
Hardware Supported: Techkeys SixKeyBoard PCB
Hardware Availability: Techkeys
Make example for this keyboard (after setting up your build environment):
make sixkeyboard:default
See build environment setup then the make instructions for more information.
Hardware Info
The schematic is like this:
switches leds
,--+--+--. ,--+--+--.
|C7|B7|B5| |C6|B6|B4|
+--+--+--+ +--+--+--+
|D6|D1|D4| |D5|D2|D3|
`--+--+--' `--+--+--'
The LED on the bottom is C4. All 7 of the leds are turned on when the keyboard boots-up in the sixkeyboard.c file - backlight_enable is not required. The MCU is an Atmega16u2, so the flash memory is limited to 0x3000 bytes - the current setup uses just about all of that! I'm sure things can be opitimised a bit.
There is a jumper on the bottom of the board (next to the USB port) that serves as a reset button - I drilled a hole in my case to allow for quick access via a screwdriver/metal object.