qmk_firmware/keyboards/cannonkeys/db60
Ryan 3a7dbc8981
Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945)
2022-08-14 12:16:16 +10:00
..
hotswap Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945) 2022-08-14 12:16:16 +10:00
j02 Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945) 2022-08-14 12:16:16 +10:00
keymaps RESET -> QK_BOOT default keymaps (#17037) 2022-05-15 20:26:27 +01:00
rev2 Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945) 2022-08-14 12:16:16 +10:00
chconf.h
config.h Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945) 2022-08-14 12:16:16 +10:00
db60.c
db60.h Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
halconf.h
info.json Move keyboard USB IDs and strings to data driven, pass 2: B-C (#17945) 2022-08-14 12:16:16 +10:00
mcuconf.h
readme.md Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
rules.mk Fix up build options comments (#15463) 2021-12-12 18:05:37 -08:00

readme.md

CannonKeys DB60

DB60 "Daughterboard 60" Keyboard

  • Keyboard Maintainer: Andrew Kannan
  • Hardware Supported: STM32F072CBT6 (or equivalent)

Make example for this keyboard (after setting up your build environment):

make cannonkeys/db60/rev2:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Some notes about the versions: The original DB60 was shipped with the J-02. To build that, you will need to use the following command:

make cannonkeys/db60/j02:default

Solderable DB60s were shipped with keyboards after the J-02. This variant has cutouts along the top and bottom to support O-ring gasket mounting. To build these, you can use this command:

make cannonkeys/db60/rev2:default

Hotswap ANSI DB60s were shipped with the Bakeneko keyboards from CannonKeys. These also have the o-ring gasket mounting points. To build this:

make cannonkeys/db60/hotswap:default