qmk_firmware/keyboards/lyso1/lefishe
Ryan ebb512db82
Debounce defines cleanup (#19742)
* Clean up `DEBOUNCE` in config.h, 0-9

* Clean up `DEBOUNCE` in config.h, A

* Clean up `DEBOUNCE` in config.h, B

* Clean up `DEBOUNCE` in config.h, C

* Clean up `DEBOUNCE` in config.h, D

* Clean up `DEBOUNCE` in config.h, E

* Clean up `DEBOUNCE` in config.h, F

* Clean up `DEBOUNCE` in config.h, G

* Clean up `DEBOUNCE` in config.h, H

* Clean up `DEBOUNCE` in config.h, handwired

* Clean up `DEBOUNCE` in config.h, I

* Clean up `DEBOUNCE` in config.h, J

* Clean up `DEBOUNCE` in config.h, K

* Clean up `DEBOUNCE` in config.h, L

* Clean up `DEBOUNCE` in config.h, M

* Clean up `DEBOUNCE` in config.h, N

* Clean up `DEBOUNCE` in config.h, O

* Clean up `DEBOUNCE` in config.h, P

* Clean up `DEBOUNCE` in config.h, Q

* Clean up `DEBOUNCE` in config.h, R

* Clean up `DEBOUNCE` in config.h, S

* Clean up `DEBOUNCE` in config.h, T

* Clean up `DEBOUNCE` in config.h, U

* Clean up `DEBOUNCE` in config.h, V

* Clean up `DEBOUNCE` in config.h, W

* Clean up `DEBOUNCE` in config.h, X

* Clean up `DEBOUNCE` in config.h, Y

* Clean up `DEBOUNCE` in config.h, Z

* Remove default debounce from info.json

* Migrate non-default debounce to info.json
2023-02-03 19:19:58 +00:00
..
keymaps
config.h Debounce defines cleanup (#19742) 2023-02-03 19:19:58 +00:00
info.json
lefishe.c
lefishe.h
readme.md
rules.mk

readme.md

lefishe

firmware for the 65xt keyboard designed around the symmetrical blocker 65% layout. This pcb cab also be used as a replacement pcb for the revoKmini/kmacmini with some modification to the design

  • Keyboard Maintainer: Lyso1
  • Hardware Supported: LeFishe, atmega32u4
  • Hardware Availability: /u/TheLysol_27

Make example for this keyboard (after setting up your build environment):

make lyso1/lefishe:default

Enter into the bootloader to flash new firmware in 3 ways:

* **Bootmagic reset**: Hold down the key at (0,0) in the matrix(The F1 key in this case) and plug the the keyboard in. 
* **Physical reset button**: Briefly press the button on the back and left side of the PCB(exactly under where the "2" key would be located) while the PCB is plugged in.
* **Keycode in layout**: Press the key mapped to `QK_BOOT` (RALT + E in this case) while the keyboard is plugged in. 

Flashing example for this keyboard:

make lyso1/lefishe:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.