56555c61e1
* Migrate `LAYOUTS` to data driven, 0-9 * Migrate `LAYOUTS` to data driven, A * Migrate `LAYOUTS` to data driven, B * Migrate `LAYOUTS` to data driven, C * Migrate `LAYOUTS` to data driven, D * Migrate `LAYOUTS` to data driven, E * Migrate `LAYOUTS` to data driven, F * Migrate `LAYOUTS` to data driven, G * Migrate `LAYOUTS` to data driven, H * Migrate `LAYOUTS` to data driven, handwired * Migrate `LAYOUTS` to data driven, I * Migrate `LAYOUTS` to data driven, J * Migrate `LAYOUTS` to data driven, K * Migrate `LAYOUTS` to data driven, L * Migrate `LAYOUTS` to data driven, M * Migrate `LAYOUTS` to data driven, N * Migrate `LAYOUTS` to data driven, O * Migrate `LAYOUTS` to data driven, P * Migrate `LAYOUTS` to data driven, Q * Migrate `LAYOUTS` to data driven, R * Migrate `LAYOUTS` to data driven, S * Migrate `LAYOUTS` to data driven, T * Migrate `LAYOUTS` to data driven, U * Migrate `LAYOUTS` to data driven, V * Migrate `LAYOUTS` to data driven, W * Migrate `LAYOUTS` to data driven, X * Migrate `LAYOUTS` to data driven, Y * Migrate `LAYOUTS` to data driven, Z |
||
|---|---|---|
| .. | ||
| galaxy | ||
| hades | ||
| venus | ||
| config.h | ||
| dgk6x.c | ||
| dgk6x.h | ||
| halconf.h | ||
| mcuconf.h | ||
| readme.md | ||
| rules.mk | ||
readme.md
DGK6X = Venus, Hades, Galaxy, etc.
This DGK6X code is shared between the ANSI variants of Venus, Hades and Galaxy keyboards.
- Keyboard Maintainer: J-Sully and dkjer
- Hardware Supported: Durgod Venus, Hades or Galaxy board with STM32F070RBT6
- Hardware Availability: Venus, Hades and Galaxy
Instructions
Build
Instructions for building the Venus, Hades and Galaxy firmware can be found here:
Initial Flash
For first Flashing from initial Stock's Firmware
- Back up original Firmware Image:
- Unplug
- Short Boot0 to Vdd (See below)
- Plug In USB
- Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:
-
Using dfu-util:
dfu-util --list dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}
-
- Flash the QMK Firmware Image.
- Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)
- Here are a few options for performing the initial Flash:
-
Using QMK Toolbox
-
Using dfu-util:
dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}
-
You can short Boot0 to Vdd by shorting R19 to C30 on the sides closest to the processor, as shown:
-
Hades & Venus:
-
Galaxy 75
Subsequent Flashing
For repeating Flashing you can use BootMagic:
- BootMagic Lite has been enabled with Assigned "Esc" key
- Unplug USB Cable
- Holding Esc Button
- Plug in USB Cable, Keyboard should be in ST-Bootloader state