qmk_firmware/keyboards/splitography
Drashna Jaelre 0da6562c4d
Make default layer size 16-bit (#15286)
Co-authored-by: James Young <18669334+noroadsleft@users.noreply.github.com>
2022-06-19 07:37:51 +10:00
..
keymaps
config.h
info.json
readme.md
rules.mk
splitography.c
splitography.h

readme.md

Splitography

Splitography

A pay what you will compact keyboard intended for use with Plover, free and open source stenography software. This is a low-cost keyboard with minimal packaging and design, and arrives fully assembled, ready to use.

Make example for this keyboard (after setting up your build environment):

make splitography:default

Flashing example for this keyboard:

make splitography:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard.
  • Physical reset button: Briefly press the button on the back of the PCB.
  • Keycode in layout: Press the key mapped to RESET if it is available.

Guide

Splitography quick start video

A short video guide on how to set up the SOFT/HRUF Splitography, a mechanical keyboard intended for use with Plover.

Here is a reference card for the standard keyboard layout:

Reference card

  • While holding down a colored thumb key, the matching colored functions/characters on the remaining keys can be pressed.
  • Bottom edge keys are accessed by holding down both keys.
  • Numlock locks in the Numpad layer.
  • Alt and Shift pressed simultaneously to return to the standard layout.